With this option enabled, user will have to enter variable value on KDU keyborard on every recall.By clicking allow or continuing to use this site, you agree to the use of cookies.NiceLabel driver can obtain the feedback of the printer status.
The status can be reported to and displayed in NiceLabel software. You can program the RFID tags embedded into the smart label. Fixed issue with Media sensitivity not being set according to selection in driver (models PD, PC, PM43 and PM23). But CPCL language prints correct just 0 and 90 degree rotation Other rotations (landscape) are not recommended. Start adjustment for PD43 models and Tear off mode is -16,6mm. Intermec Easycoder 3400E Code But KeepBefore this correction IPL printer ignore parentheses and spaces in the bar code but keep them in the interpretive field. The limitation is use of automatic aspect ratio and square shape of the code. Current version support paths up to 260 ( MAXPATH ) characters. Now they can change language settings if they have administrative rights. Export to printer or StoreRecall functionality is working now also with variable data on 2D barcodes (PDF417, MicroPDF417, Datamatrix). Intermec Easycoder 3400E Drivers Advanced SetupThis is corrected now and printer receives pre-defined values for start and stop adjustment visible in the drivers advanced setup dialog. Intermec Easycoder 3400E Series But NotFont list have been taken from PM series but not all fonts are available on PC series. ![]() In Labeling software user can just set the antenna offset as positive value, so if user would like to set the same value in negative direction he must select Negative Antenna Offset in the driver settings dialog (Advanced setup OtherMiscellaneous. If connected to standard Windows TCPIP port then show warning message. The status reporting issue was limited to NicePrintQueue, Enterprise Print Manager(EPM) and NiceLabel. Shift size depends on page dimensions, shift direction depends on rotation. If user selects Feed label after writing and Delay before feed additional commands LABEL, SET-TOF and FORM are sent to printer. Also page width and memory size for P4T and RP4T printers was increased. Corrected also Max page lengths for PM, PD41 and PD42 models. A click on the shielded button and entering the credentials is all that is needed. This is corrected now and correct dimmensions are sent to the printer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |